14_clipped_rev_1-1

The Model C3A-M ChamferMate® Combination Chamfering and Parts Marking Machine is a compact chamfering and stamping combination unit that features a rigid one-piece ductile iron vise, linear ball rails, heavy-duty three-bearing spindle, through-the-spindle stop rod with marking insert capabilities, and an electronic variable-speed drive to provide years of dependable service.

With the addition of the marking stop rod, customers can use the C3A-M as either a chamfering machine, parts marking machine, or a combination of both functions. With use of the selector switch, users can chamfer and/or stamp ends of studs and bolts with ease.

The new C3A-M will offer a diameter range of 3/8”-3” and have cycle times as low as 3 seconds per side. Adjustments are all mechanical, so no need to rely on expensive electronics like that of the competition. The C3A-M is equipped with a pneumatic cylinder that packs 16,000 pounds of force, leaving a clear, deep, easily legible stamp on the ends of bolts and studs that far exceeds that of the competition.

Model C3A-M ChamferMate® Combo Unit Standard Features:

  • 3/8" to 3" OD Diameter Capacity
  • Chamfer and stamp in one easy process
  • 500 to 2000 rpm electronic variable speed drive
  • Adjustable cutter head for OD chamfering
  • Ability to chamfer (only), stamp (only), or both functions in the same cycle
  • Totally enclosed cutting area with chip drawer
  • Fully adjustable feed rate
  • Through-the-spindle stop rod with marking insert holder
  • 3-HP / 3 phase motor
  • Forklift slots
  • Collet and tool rack on side
  • Compact 24" x 36" floor space

Fact Sheet Maintenance Guide Spare Parts List

Fastener Fabrication Spec Sheet

Chamfering and Beveling Benefits

  • No more hand grinding or beveling in a lathe
  • Many times faster than had methods
  • Chamfer and stamp in one easy process
  • Cycle times normally in the 2 to 5 second range
  • Totally enclosed cutting area for safety
  • Accurate repeatable chamfers
  • Sturdy construction and quality materials for years of dependable service
  • Low operation cost

 

SPEC C3A
Diameter Range 3/8" to 3" OD
Pipe Size Range 1/2" to 2-1/2"
Center Height 39-1/2"

"Typical Wall Thickness 
Varies with diameter, material, and profile. Consult Factory for your specific application.

N/A

Horsepower (Std) 3 HP
Voltage/Amp (1) 220-3-60 / 20A
  440-3-60 / 10A

Standard RPM Range
Consult Factory for your specific RPM application.

500-2000

Pneumatic Requirement 4 CFM @ 90 PSI
Clamping Pneumatic
Spindle Feed Air over Oil
Feed Rate Adjustable
Spindle Stroke 3"
Coolant Optional
Pipe Stop (Sliding Stop) N/A
Type of Head (Std) Single Tool OD Only
Optional Head (2) N/A
Physical Size 27"W x 35"D x 45"H 
Appx Weight Lbs 1,000 lbs
 
NOTES
(1) Other voltages and frequencies available for additional cost.
(2) Custom heads and tool holders for special angles, J-Bevels, OD Hollow Milling, ID boring, Center Drilling, etc., are available.
 
NOTE: SPECIFICATIONS SUBJECT TO CHANGE.
 
All of MSI's chamfering machines and beveling machines can be customized to meet your individual production needs.


Specifications