The Model C3A-M ChamferMate® Combination Chamfering and Parts Marking Machine is a compact chamfering and stamping combination unit that features a rigid one-piece ductile iron vise, linear ball rails, heavy-duty three-bearing spindle, through-the-spindle stop rod with marking insert capabilities, and an electronic variable-speed drive to provide years of dependable service.
With the addition of the marking stop rod, customers can use the C3A-M as either a chamfering machine, parts marking machine, or a combination of both functions. With use of the selector switch, users can chamfer and/or stamp ends of studs and bolts with ease.
The new C3A-M will offer a diameter range of 3/8”-3” and have cycle times as low as 3 seconds per side. Adjustments are all mechanical, so no need to rely on expensive electronics like that of the competition. The C3A-M is equipped with a pneumatic cylinder that packs 16,000 pounds of force, leaving a clear, deep, easily legible stamp on the ends of bolts and studs that far exceeds that of the competition.
Model C3A-M ChamferMate® Combo Unit Standard Features:
- 3/8" to 3" OD Diameter Capacity
- Chamfer and stamp in one easy process
- 500 to 2000 rpm electronic variable speed drive
- Adjustable cutter head for OD chamfering
- Ability to chamfer (only), stamp (only), or both functions in the same cycle
- Totally enclosed cutting area with chip drawer
- Fully adjustable feed rate
- Through-the-spindle stop rod with marking insert holder
- 3-HP / 3 phase motor
- Forklift slots
- Collet and tool rack on side
- Compact 24" x 36" floor space
Fact Sheet Maintenance Guide Spare Parts List
Fastener Fabrication Spec Sheet
Chamfering and Beveling Benefits
- No more hand grinding or beveling in a lathe
- Many times faster than had methods
- Chamfer and stamp in one easy process
- Cycle times normally in the 2 to 5 second range
- Totally enclosed cutting area for safety
- Accurate repeatable chamfers
- Sturdy construction and quality materials for years of dependable service
- Low operation cost
SPEC | C3A |
Diameter Range | 3/8" to 3" OD |
Pipe Size Range | 1/2" to 2-1/2" |
Center Height | 39-1/2" |
"Typical Wall Thickness |
N/A |
Horsepower (Std) | 3 HP |
Voltage/Amp (1) | 220-3-60 / 20A |
440-3-60 / 10A | |
Standard RPM Range |
500-2000 |
Pneumatic Requirement | 4 CFM @ 90 PSI |
Clamping | Pneumatic |
Spindle Feed | Air over Oil |
Feed Rate | Adjustable |
Spindle Stroke | 3" |
Coolant | Optional |
Pipe Stop (Sliding Stop) | N/A |
Type of Head (Std) | Single Tool OD Only |
Optional Head (2) | N/A |
Physical Size | 27"W x 35"D x 45"H |
Appx Weight Lbs | 1,000 lbs |
NOTES | |
(1) Other voltages and frequencies available for additional cost. | |
(2) Custom heads and tool holders for special angles, J-Bevels, OD Hollow Milling, ID boring, Center Drilling, etc., are available. | |
NOTE: SPECIFICATIONS SUBJECT TO CHANGE. | |
All of MSI's chamfering machines and beveling machines can be customized to meet your individual production needs. |